al wrist_in_timeouts wit Trendsetter_400/800_Auto Trendsetter_NEWS This parameter keeps track of how often the version 3 picker times out waiting for vacuum. This is usually a problem with the picker wrist not moving in properly. If this situation is detected, the firmware will actuate the plate pusher to try and reseal the wrist cylinder. (as of ECO #D388, 100 label #24, the plate pusher is plumbed such that it actuating it bypasses the fixed orifice that controls the speed of the wrist in motion. This high/fast flow causes the cylinder to re-seal.) After actuating the plate pusher, the firmware will check the vacuum level. If it is still low, a low vacuum error will be reported. If the vacuum level is okay, the pick sequence will be continued without a suspend. This parameter is updated automatically when an error occurs. It should not be changed. It is possible for this counter to be incremented without a suspend error ever being reported to the operator. This counter is often an indicator of potential picking problems that can be fixed before they become an inconvenience to the customer uint16
  • 0
    •
  • 0 to 65535
    •      Only supported in firmware versions 1.40 and above. state
  • ../commands/pick.xmlCommand: pick
  • ../commands/picker.xmlCommand: picker
  • ../nvs/al_cfg_vpi.xmlNVS: al vpi
    •
  • ..\..\ShowAllErrors.htmFirmware 0 Error Index
  • ..\..\ShowAllCommands.htmFirmware 0 Command Index
  • ..\..\ShowAllNVS.htmFirmware 0 NVS Index
    •  Updated: Wed Jul 16 19:36:05 2008 PST